Problem Firmware (1.31) DJM900nxs
Dear friends, I updated the firmware DJM900NXS mixer (1:31), made the entire procedure until the success message, ran only twice. Now the mixer no longer starts when you connect it blinks three times the LFO FORM button and the mixer will not start. What happens?
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Official comment
@Dide > Sorry to say but that is a hardware failure indicator - you'll need to contact Pioneer technical support for service or repair information.
@Dide > Are you able to boot the mixer into firmware update mode?
Unfortunately not! I'll have to change the motherboard?
I can not even begin to do Mixer update. He stops at startup and flashes 3 times the LFO FORM, not out of it. What should I do? Help me!!
@Dide > Does the display show anything at all or is it only the LFO FORM LED that blinks?
Is it blinking in a pattern of 3 blinks then off, then repeat?
Hello! Flashes the LFO FORM three times off for 1 second and will flash again three times. It is also lit X-pad and the channels 1, 2, 3 and 4, MIC A, B and MST, parameter 0 is 0 and the display. It behaves as if the mixer had caught. Nothing in mixer or more lights work. Is it no problem at source of energy?
6 comments