SP16 global utilty changes
Thanks for getting back to me so quickly for the firmware 1.3 to 1.5.
I have another small question: My SP16 is in "slave clock" mode and my Roland TR8S is in "master clock". When I go to "Utitlity" in my SP16 to change some parameters (ex: CC - disable): when I turn off the SP16 and turn it back on, the parameters return to their initial state (ex: CC - enable). Is this normal? it is not possible to save the changes permanently?
Thanks again,
Laurent
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Official comment
Hello Laurent,
Are you saying your project before shutting down the unit?
Usually the unit will stay with the parameters it was last used with because when you turn it on it will reload the last project that was loaded.
1 comment