DJM 900 nexus2 digital route and send/return
Hi
Yesterday i connected my cdj on the digital ports.
Also hooked up my rmx 1000 to send/return.
But send/reurn doesnt work. No input from the digital chanels....wtf.
I had to switch the cdjs to analog input and then it works.
On my older djm900 nexus it was no problem
Fw 1.20
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Official comment
It does work, in being able to go between analog and digital sources, but I have a test-production model and it's behaving erratically with regards to the channel selection for sending a channel to the FX (S/R). I'm going to have to get one of our product managers to provide an answer for you.
I think the digital is routed to the new S/R on the new input for S/R top right. I'll look into it.
I send/return as I do it always...
But if the input goes from chanel1-4 by digital, its not working
I rewired it back to analog on chanel1-4 and it works
So I think, the digital signal doesn't routed trough send/return
Do you have the Send/Return switch turned to [1/4" Jack] and set to [Insert]?
4 comments