DJM 900NXS2 phaser issue
So am I the only one that notices that the volume jumps down when I initiate the PHASER Effect?
Or is anybody else having this issue.
Note: I have the latest Firmware.
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Official comment
That's because of how the effect operates and the intention to not have the audio clip due to an increased level during the effect.
Yes, this might be by design as before updating firmware it was the same.
I think it was the same with my NXS1 mixer as well.
Bit crap really.
Crap? That's a tad harsh. Would you rather have the club sound system output an excruciatingly loud pop/clip that would no doubt create an awkward moment for the crowd in addition to potential damaging the venue's audio system? That's what happens if the phasing effect were to begin modulation on a peak rather than a trough when being applied to a "loud" signal. Huge peaks in the frequency spectrum are never a good thing–nor is the resulting digital clipping.
3 comments