HID & CDJ-2000nexus
Is there a mapping that will enable me to perform the Loop Cutter when using my CDJ2000's & Traktor in HID mode?
Normally, I would press the LOOP MODE on the deck and the waveform display is replaced with a series of loops which are triggered
when a certain part of the needle search strip is pressed.
Would love this function when I'm using my CDJs with TP2.
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Not as such thanks to the limitations of the software and HID mode.
1 comment