[CLOSED] DJM-900 Nexus only boots into Update moed FW 1.28
I recently upgraded the FW to 1.28 with success. After about a week whenever I power it on, it goes straight to the update mode. How do I exit it or go back so I can use it? Need help ASAP!
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
been a while since I used a 900 but have you looked to see the buttons you pushed are not stuck? Just a thought and maybe try to update again with a fresh copy of the firmware. It could be that the original FW had issues in it when you transferred and or downloaded it. It happens.
Nothing stuck, can't update it because its frozen. Lfo light top right is flashing red
Based on another post (just to help you speed things up for assistance) I have seen one of the Mods ask how many times it blinks (to identify the error code).
Look at that and post it and or a short video if you can so they can help you right away.
Good luck
Having the exact same problem with the 350, any help appreciated.
Hope by now you've called tech support. Number is at top right of this page and every page here.
I've raised a ticket with the engineers to see what they recommend - please standby for a response.
Ok guys, some questions by the engineers:
Does it flash more rapidly than the Beat FX ON/OFF button when turning it on?
For example, “Flashing 5 times” means “Repeating the process that the button flashes 5 times, then stops lighting for 1 sec.”
Closing ticket due to lack of response. If issues persist, please open another thread.
8 comments