Requesting One suitable Overhang gauge.

I've started using PLX-1000 for about two months.

However, you must appreciate that the overhang measurement of 54mm as suggested in your manual by a simple two-dimensional drawing print is practically not feasible & convenient to the correct extent in as much as there is no support/binding guard at least in the rear-side in such a drawing.

I've searched in the markets of both online & offline in the entire country but failed to get any.

So, requesting you, to please arrange for such an item/gauge for me which in my opinion also should be a supplied as accessory along with the main unit in future for all.

By the by, I'm an user of TT for last 45 years & the earlier model EMISONIC DD TT is still serving robustly simultaneous with this new acquisition without any disturbance. 

Please consider my proposal judiciously towards perfection which is obviously the intended tagline for such a genre & product....Thanks.

Amitava Chandra

9836270620