DJM-350 firmware update will not run
Trying to update the firmware on my djm-350 black using the effect switch bin file. Blank fat32 usb drive, djm0506.bin in the root of the drive, put into standby mode, hold both fader start buttons, power on, channel 2 red light blinks for about 1 second, then all lights on second channel go solid, and second from the bottom green light on ch1 is solid as well. Tried multiple drives, 1.04 firmware file as well, no change. Saw one other person with issue in forum, no responses as to how to fix. Help??
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
should note, lights remain like that forever untill holding power to shut off. Still boots fine, but still running 1.04 firmware
sorry for the triple post. going to zero the drive to make sure the djm update isn't failing because of old data on the drive.
same result
@Quinn > How did you format the flash drive?
tried fat32 and fat16 through both Windows format utility and Gparted. zeroed the drive using both erasing all files and 'cat /dev/zero > file' and deleting that file, and 'ddr if=/dev/zero of=/dev/sdb' and reformatting to fat32
also tried formatting via mkfs.fat32
@Quinn > Can you please try with this tool?
http://www.softpedia.com/get/System/Hard-Disk-Utils/HP-USB-Disk-Storage-Format-Tool.shtml
that worked, you are an internet hero, sir
Woohoo! I was worried there for a minute! Thanks for reporting back.
9 comments