PIONEER DJM-T1 TRIM KNOB PROBLEM!! HELP!!!
I have a pioneer DJM T1. Mixer worked great.. Recently, for some odd reason my trim knob on channel 1 does not work properly. The volume stays high and and when I try to lower it, it only lowers a little, but never completely down. The gain on this channel is always red lining. It does this using normal vinyl and Traktor scratch duo and serato. I actually opened it up, as I thought it was the trim pc board, and switched it with the TRIM knob from channel 2, but the problem continued on Channel 1. SO I know its not the PC board.
Weird as it was working fine. This only occurs on the TRIM knob and channel 1.
Any help would be appreciated.
djduke
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
@Duke > My apologies for the delay. Have you updated the firmware / drivers and software (available here)?
Gaving thanks for the reply.
I have no attempted. I will do it tonight and see if it works? Could it be anything else? As I know at one point it was working fine with the drivers it already had.
2 comments