[OPEN] Reupdating XDJ R1 1.09 FW
Hi,
I have updated the FW on my r1 with but I'm getting some problem's I phone some support they said just try and update it again ..
When i try and do this it just goes complete with in 5 seconds ??
How do I do this ?
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
No one around
What are the problems you're having?
Dear Pioneer,
I have tried to write to this forum 2 times, but after I sent my problem the system answered my message will check firstly.. then .. there is no any respones at all.. (my e-mail is: denes@salsadiabolica.hu)
I have a several problem witm my XDJ-R1, I have bought it in august (in Hungary), I have updated all the times when a new firmware was relased..
My symphtom is: In most cases we use CD, after starting a party, (after a time: somtimes 1 hour, sometimes 2.. but until now all the nights!!) the XDJ starting to "jumping" in the music, when I put a new CD and would like to set the cue point.. If I try more then 3 times to set with that CD, system will crashed, (it means, the other side, where the other CD is playing is freezing..)
If I reject immediately, the other side will play normally.. but in this case I have to find another way to play music, (like iPod or any Phone or MP3 player) because until a completely restart never paly again any CD normally.... after a restart the system can play CD again normally.. (can play that CD what I tried before the restart). but it is working again... only for a time.. for 1 hour... (sometimes only 30 min) and the symphtom appear again...
I recognized, I can change (raise) the time between 2 crashing if I switch off the autocue... but, even I do this, the "juming in the music" effect will appear sooner or later (in 1 night..).. Sometimes culd help, if I switched to USB source then back to CD.. but sometimes not..
On the other hand,.. I can do this "Correcting triying" only while the music is going in the other side... wehen the music is ended... I have no time to try..
What do you think, Can help a firmware reload?.. (Curr version is: 1.09)
Or Do I think well this can it be a kind of puffer problem?.. because all the times, the XDJ starting work correctly, and always after a time start to crash..
Thank you,
Denes
3 comments