[SOLVED] DJM-900 nexus - How to Midi Map?
Hello Gurus:
I have a question about mapping two channel faders on the 900 nexus to two channel faders of my software (mix emergency for videos.) After I am done mapping the channel faders, do I have to leave the ON/OFF [Utility] button on the ON position in order tu use the mappings?
In the past I used equipment where I could turn ON the MIDI functionality, do all my mappings and then after recording al my mappings I would turn the MIDI functionality OFF on both the mixer and the software, and then I can use the controls on the mixer to operate the controls of the software. But with the 900 nexus, if I turn the ON/OFf [Utility] button OFF, I can no longer manipulate the software with the mixer.
Is that how it works on the 900 nexus? Does the utility button must stay ON all the time? Or can I turn it on, record the MIDI mappings, turn it off, and then able to use my mapping.
Please advice.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
@Eduardo > If you turn the MIDI OFF (the ON/OFF button at the top right), it will stop sending MIDI signal, so yes, you need it ON.
@Pulse > Thank you very much sir. I am still learning how to use this fine piece of equimpment; I love it. Thanks again.
Moderators: You can close this thread as [SOLVED]
3 comments