use DDJ-XP2 as a control surface for Ableton
Hi,
I Would like to use my XP2 as a control surface to Ableton Live 11.
The idea is to use this setup as a sampler. So, I would like to load my samples, kicks, drums etc. in Ableton as clips in session view.
Then from the XP2 I would like to be able to trigger the clips.
If I'm not mistaking the XP2 can also be used as a midi control device. So, would be useless to buy a Novation, Ableton Push 2 or Akai midi controller when I already have 32 pads on my XP2, right.
Is there a midi mapping available?
Thx for helping!
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Yes!
Kinda found an answer here: https://help.ableton.com/hc/en-us/articles/360000038859
So, I can launch my clips with the XP2, but there's a delay.
You can adjust the MIDI timing in the Ableton preferences.
The solution was setting the quantize to none
4 comments