Updating from DJM-750MK2 to DJM-900NXS2
I've been using the DJM-750MK2 while my DJM-900NXS2 was in repair
do I need to uninstall the DJM-750MK2 drivers re-boot
and than install the DJM-900MXS2 drivers before I install
the DJM-900NXS2 mixer?
also will it install any of these drivers?
Probably not a good idea to over-write
old drivers, I’m I correct? How do I get these
1.CDJXDJ ASIO utilities
2.CDJXDJ Version display utilities
3.DJM-900NXS2 setting utility
Will these drivers automatically install on there own?
the DJM-750MK2 install all of these when I hooked
up that mixer, the reason I'm asking is I had a lot
of problems with the DJM-900NXS2 drivers, for some
reason it didn't install all of the drivers needed to run
the DJM-900NXS2 w/ rekordbox in performance mode.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Official comment
You don't need to uninstall the 750. If you never plan on using it again, you can remove them.
Yes, you need the 900 drivers, the utility comes as part of the audio driver package.
Unless you're using a CDJ or XDJ, you don't need those drivers or utilities.
If you have troubles with them, be sure to have your Windows 10 fully updated and run the driver installation in administrator mode.
1 comment