[CLOSED] HID does not work ? And a lot of latency in Timecode CDJ2000
Hi just bought serato.
Wen I set it up. Every time I wanna cue with the platter in scratch mode. The track runs out of position.
Check out my movie
https://www.facebook.com/photo.php?v=406457112700758
In HID mode CDJ can't start my tracks . I can se my tracks on my CDJ , I can select them but do not play.
Btw tell me if you can see my video then I load up a new one in Facebook with my settings and HID problem
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
in HID mode Serato has to be in INT mode, not ABS
Ah oky. HID works ! . Now my time code. Can you see the video?
it looks like it is moving after to stop, so drifting a little, go into the serato setup and lower the threshold a little, drop it like halfway or a little more then that to the right
Uhu I tried this. Is a lithe less drifting but still to much. Also when I put it more to the right the platter loses response :s
yeah not sure what to tell ya at this point, i know the drifting after stop has always been a problem but most people use REL mode with timecode so jumping the timecode up a couple of seconds avoids your issue. I couldn't imaging using ABS mode personally
Check out new video . You can see if I drastically increase the threshold the platter response drops drastically.
So serato does not respond to slow platter movement . with makes it also difficult setting a cue point. If I put it in the middle . It does not respond to slow movements and there is somme latency.
https://www.facebook.com/video/video.php?v=407045602641909&saved
Is this normal ?
yes
7 comments