DDJ RX: Crossfader cut lag adjust HOW?

1. Turn the unit off
2. Disconnect USB cable
3. Press and hold the SHIFT and PLAY buttons of the left deck and press the power button to turn the unit on to enter Utilities Mode
4. The cut lag value (0-52) is indicated by the number of LEDs that are lit on Channels 3 and 1. Channel 3 indicates the first digit, Channel 1 indicates the second digit.  For example:  In the image below channel 3 shows 3 LEDs and channel 1 shows 5 LEDs.  This means the cut lag is set at 35.
   
   
   
5. Turning the rotary selector knob will adjust the cut lag up or down.

It's the knob on the far right front panel, turn that to adjust the curve.

sorry, this knobs don't work and crossfader it's too cut

or left, or right, or center don't have effect on crossfader

Hi Mark,

with this operation can i have a smooth crossfader curve?

How can i set for this?

There is a MAJOR difference between Cut Lag and Crossfader Curve.  The procedure above changes the cut lag.  To adjust the curve, use the knob on the front panel.  

see my small video and listen Crossfader curve don't work, it's too HARD

https://www.facebook.com/100011307162963/videos/291079547945615/

don't work A channel 100 - 50 - 0

                 B channel  0 - 50 - 100

actually work (see image):

Then you need to adjust your cut lag to lower number.

you and how can I do? if you saw the video I posted in the link you can understand and feel my problem

I gave you the step by step instructions above.