MWM Phase with Rekordbox DVS
Trying to get this to work.
So, Phase instructions say to use Line input, so I do plug in the RCAs from the Phase box to the line input. I have the USB connected from a DJM-450 to Rekordbox. When I go to DVS calibration screen, I get all 0's when using the line input on the line input selector. I can hear the control tone loud and it fluctuates depending on if I move the record with phase remote on top.
However, following the DJM-450 manual, I switch the input to PC and I don't hear the tone anymore, but at least now in calibration it shows something more than 0s - albeit like .0005. Wave forms of tracks show up and the track "plays", albeit terribly, indicating poor calibration, but attempting to calibrate fails - auto or manual.
Any guidance of things I can try? I've had this working with needles and serato control vinyl.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
You'll need to go into the DJM-450 utility setting and make sure that CH1 / 2 is set to Line input - Control tone.
Do yourself a favour though, stick with the control vinyls! I had my phase from release day and sold it shortly after due to it just being unreliable! Its not massively accurate either.
@Elevate > You may also need to adjust the size.
I have issues where my phase is not even spinning and the grid is moving itself? I have also noticed its not moving the grid as accurate as my traktor program would? I have read a few things about latency and seen this doesn't fix it? Please tell me I have brought an item that still hasn't been rectified. This is on a ddj1000 just purchased.
Phase is not unreliable @ramondbell it works superb on my traktor.
@nigel - To be fair this was nearly 3 years ago!
FYI Pioneer won't be able to provide a resolution at Phase isn't an official accesory.
However, I may be able to help as I use it daily.
5 comments