DJM S11 - Smooth Echo Related
My S11 is not saving smooth echo settings parameters after a power cycle every time.
The mixer has the latest firmware installed.
Also the the latest version of Serato is installed on the laptop (Windows 10)
Any help would be appreciated.
Thanks
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
If you're connected to the computer, it's possible the parameters are being overwritten by the utility app; does this only happen when it's connected?
I just tried some further troubleshooting steps.. when i power up the mixer before launching Serato, the echo settings seem to be holding. If i start Serato first then start the mixer, the settings do not hold..
If i disconnect the usb cable to the mixer, the echo setting do not hold the parameters that were set previously.
Thanks
I had this same issue. I had to enable pc utility on the mixer. To do this go to the cog wheel > other settings > Pc utility > and set to on. After I turned that option on the settings saved.
3 comments