problems knobs ddj-ergo vs VDJ LE
Hi i have a few problems with the ddj-ergo and the virtual dj le software:
- the master volume and headphone volume knobs works fine on the ddj-ergo but the graphic on the Virtual DJ LE software doesn’t move.
- when i mix, the gain knobs need a bit of a jiggle before they will work each time, i see that they have sometimes another position at the graphic on VDJ LE and the ddj-ergo
Post is closed for comments.
Can't find help? Search our Support Site or alternatively, reach out to our Support agents
Hi,
I've got the same problems with Virtual DJ LE en the gain knobs.
as you can see in the screenshot provided below :
Go to your "Config" then go to "Options" disable all auto resets , This will keep the buttons in the same position as your controller even if another track is loaded.
LE does not provide those additional tabs within the configuration settings.
For @Kris and @Kunal > Did you have another version of VDJ installed prior to installing the version that came with the ERGO? Have you updated the ERGO firmware to the latest version?
I have installed only the version of VDJ that was on the cd-rom with the ddj-ergo (Virtual DJ LE Version 7.05).
Yes, latest ergo firmware is 1.20
I have installed also only the VDJ LE from the cd.
My firmware is the latest one 1.20 and driver version is 1.100
I removed the pioneer software and VDJ LE and reinstalled everything(firmware update, Pioneer driver and Virtual DJ LE).
Still i've got the same problem.
I 've got a another problem.
The pitch sliders are not responding.
Sometimes i must bring the slider up and down, and then i get response from the slider.
Yesterday i downloaded the software Serato Dj intro and installed it.
I've got also problems with this software.
I have tried the controller on a another PC and used a another USB cable but i get the same problems.
I get the feeling that this is not a software problem, but a hardware problem
I would try re-flashing the firmware. I know a few units we did for Pioneer shows would appear as 1.1 and yet they acted as 1.0.
i reflashing the firmware. Firmware is 1.1
But, same problems!
Hi,
I send the controller back to my distributor.
They are going to check and test it
@KrisBrac do you test your controller with Serato Dj Intro software?
Guys, this is by design, read here, it's soft take-over. If the software adjusts a setting for you, and it's not matching the knob, you must "wiggle" it until it follows.
http://www.virtualdj.com/wiki/Pitch%20slider,%20volume%20slider%20or%20gain%20knob%20does%20not%20respond.html
10 comments